# Inventory and topology

Find any object in your estate, and see what depends on it.

## The steps

1. In the search field of the top bar, type the name of a machine. `⌘K` on a Mac, `Ctrl+K` elsewhere, puts the cursor there.
2. Open its panel: its resources, network, storage, risks, recommendations and latest changes are all there. Its **Topology** tab shows what surrounds it.
3. Go up to its host or cluster through the panel's breadcrumb.
4. Open **Topology**, under **Infrastructure**, and choose that cluster.
5. Spot the busiest hosts: each machine is a cell, colored by its load.

## When to use what

| You are looking for | Go to |
|---|---|
| A specific object | The search in the top bar |
| A list to filter or export | **Inventory** |
| What runs where, and at what load | **Topology** |
| Physical servers and their racks | **Inventory**, **Hardware** card |

## In the inventory

The cards at the top count your machines, hosts, clusters, datastores and networks. They also act as filters: one click lists what they count. The tree on the left follows the datacenter, cluster, host hierarchy, and expanding a host loads its machines.

## In the topology

- One source at a time: its chips let you switch from one to another.
- The **HA** badge says whether the cluster withstands the loss of a host.
- Below the hosts, the shared datastores, and the arrays that carry them when an array is connected.

> To know whether a cluster absorbs the loss of a host, do not trust the impression the map leaves: the simulator calculates it. That is the topic of the [Steer and decide](/en/steer) path.

### The Topology card of the inventory says "not configured"

It refers to the sites and rooms you declare by hand, not to the Topology page. As long as you declare none, the scenarios that depend on a room remain unavailable.

### A machine I am looking for does not appear

Check the top bar filters and your analysis scope, then the last collection of its source. A machine created after that collection will appear at the next one.
