Lesson 2 of 7

Filters and scope

5 min All users Updated
Objective

Know at all times what you are looking at, and change it.

The steps

  1. In the top bar, choose a datacenter, a cluster or a source instead of All datacenters, All clusters and All sources.
  2. Change page: the filter follows you everywhere.
  3. To read the past, choose a specific collection instead of Latest.
  4. Click the circular arrow at the end of the filters, Reset filters, to go back to the present of your whole estate.
  5. Open Settings › My account › Analysis scope to set aside what does not concern you.

Three things not to confuse

Setting What it changes For whom
The filters What you are looking at now You, for your session
Your analysis scope What never interests you: Home, risks, reports and exports Only you, until you change it
An alert exclusion The alerts of an asset, for a stated reason The whole company

Setting an asset aside from your scope deletes nothing: it stays collected, and your colleagues still see it.

The consolidated present

Without a filter, each page shows the last successful collection of each of your sources, brought together. A late source therefore keeps its last picture, and says so: Naoshift never mixes two dates of the same source.

A colleague does not see the same totals as you? Compare your filters first, then your analysis scopes. It is the first cause of a gap.

If you get stuck

The filter does not offer my cluster

It may have been set aside from your analysis scope, or its source has not collected yet. Check your Analysis scope, in Settings › My account, then the state of the source in Data sources, at the bottom of the left menu.

Go further

Try it on your estate

Naoshift Core, 30-day free trial. No credit card, no commitment.

Start my free trial